![]() Use and to calibrate the hands so that they both point to position 12.0:00 flashes on the display and both hands move to position 12. Press the to switch to the minute and hour hand calibration.Use the to calibrate the hands to position 12.Hold, H-SET will be displayed and SUB will start flashing (ie you are now calibrating the dial knob at position 12).If the analog hands do not display the time shown on the digital display, the hands must be calibrated. How to calibrate hands of the Casio GA-100? The always moves to the setting of further data.Use the and to select the desired value.Hold down until the time zone starts flashing.Switch to the basic TIME mode (modes are switched with the ).How to set the time on the G Shock GA 100? A short press of the controls the activation / deactivation of the respective alarm clock. Use and to set the alarm hour, then press. You can now use the to switch between the individual alarms in this order:ĭrive to SNZ (repeated alarm clock). Then the automatic alarm will turn itself off. If this does not happen, the alarm will repeat every five minutes, but no more than 7 times. It is necessary to end the repeated alarm by turning it off directly in the alarm mode (this is not possible by pressing a single button). But the alarm will continue to run in the background and start ringing again in 5 minutes. When the recurrent alarm sounds, you can interrupt it by pressing any key. The watch has 4 regular alarm clocks and one recurring one. The automatic lighting deactivates itself every 6 hours. You can tell if the auto light is on by the lower left status indicator (A.LIGHT). ![]() Automatic lighting is activated and deactivated by holding down the for a longer time (3 seconds), but you must be in the basic TIME mode. How do I turn the automatic lighting on/off for the Casio GA-100? SNZ - indicates Snooze alarm on/off (repeated alarm).The light turns on automatically when the watch is tilted toward the face (the watch monitors the tilt angle). A.LIGHT - indicates automatic lighting on/off.SIG - indicates on/off of the clock sound signal.Labels are marked (although they are quite hard-to-read on the watch): TIME > STW > TMR > WT > ALM What do the status indicators mean?Īt the top left of the watch display, four status indicators are displayed on a small circular display. You can recognize the basic mode (TIME) by the three-letter abbreviation of the day in the right part of the display. From the last mode, you get back to the first. Switches between modes using the (MODE) button. The GA100 has 5 modes: local time, stopwatch (STW), countdown timer (TMR), world time (WT) and alarm (ALM). What are the features of the Casio G-Shock GA-100 and how can you switch between them? How do I switch the time to a different time zone on the GA-100?.How to turn on/off the hour sound signal?.How to enable/disable daylight saving time (DST)?.How to calibrate hands of the Casio GA-100?.How to set the time on the G Shock GA 100?.How do I turn the automatic lighting on/off for the Casio GA-100?.What are the features of the Casio G-Shock GA-100 and how can you switch between them?.
0 Comments
Leave a Reply. |